Bosch Fridge / Freezer parts - repair your Bosch Fridge / Freezer with a Fridge / Freezer spare part from Currys Partmaster. Worldwide and Next Day UK delivery. Manual for Bosch KGV28323GB/02 - Microwave Ovens question.

I don't suppose anyone can assist me with this issue. My fridge has started getting warm and the freezer stops frosting. When I switch off for a few hours, then start up, eveything works as it should. However, after an hour or so, the gas stops circuclating in the freezer, the fridge starts to warm and the compressor gets very hot, as it continuously runs. The thermostat in the fridge only switches on or off.

There's no other setting in between. I've replaced this, hoping it was this, but it wasn't.

I haven't done a thorough defrost but I have done a couple of hours one, with a hairdryer in the freezer section to speed things up. I'm satisfied my fridge freezer isn't completely beyond help but i'm not sure where to go from here.

I have a 14 day return on my stat, starting from yesterday, and would appreciate any help from the more experienced. It cost me £40 I'm a qualified electrician covering all sectors and feel competent in working on my freezer, albeit a little blindly. Kind Regards Mike Whitegoods Newbie Posts: 4 Joined: Tue Jun 09, 2009 12:00 am.

The most common cause for this condition is a problem with the defrost system. The defrost heater turns on several times throughout the day to melt away any frost that may have accumulated on the freezer evaporator coils. If the defrost heater won’t turn on, frost will continue to accumulate on the evaporator coils, and the coils will eventually frost over.

Gale Subwoofer Manual more. To determine if the defrost heater is at fault, use a multimeter to test the defrost heater for continuity. If the defrost heater does not have continuity, replace it. The condenser fan motor draws air though the condenser and over the condenser coils. If the condenser fan motor is not working properly, it won’t draw air through the condenser, causing the refrigerator not to cool. If the condenser fan motor is not running, check the fan blades for obstructions.

Next, ensure that the blades spin freely. If the fan blades do not spin freely, the fan motor bearings are worn out, and the fan motor should be replaced. If no obstructions are present, and the fan blades spin freely, use a multimeter to test the fan motor for continuity. If the condenser fan motor does not have continuity, replace it. The temperature control thermostat directs voltage to the compressor, evaporator fan motor, and condenser fan motor. If the thermostat is not working, the refrigerant system will not get power and the freezer will not cool. To determine if the thermostat is defective, rotate the thermostat from the lowest setting to the highest setting and listen for a “click.” If you hear a click, the thermostat is not likely defective.

If you do not hear a click, use a multimeter to test the thermostat for continuity. Chutti Tv Programs Download. If the temperature control thermostat does not have continuity, replace it.

The compressor is a motor which compresses the refrigerant and circulates the refrigerant through the evaporator and condenser coils. If the compressor is not working, the refrigerator won’t cool. However, this is rarely the case. Before replacing the compressor, first check all of the more commonly defective parts. Marvel Agents Of Shield Season 1 Download more. If you have determined that all of the other components are working properly, check the compressor. Use a multimeter to test the continuity between the electrical pins on the side of the compressor. If there is an open circuit, the compressor is defective.